What should I do if my RAD LINE cord has sheath slippage?
Your RAD LINE cord has sheath slippage and you still want to use it... Follow the steps below to extend the life of your RAD LINE.
- Read the technical notice before viewing the following techniques.
- It is important to fully understand the information provided in the technical notice before using this complementary information
- Mastering these techniques requires training.
- Consult a professional before attempting to perform these techniques on your own.
Start by doing a full inspection of your RAD LINE with the help of our PPE inspection form.
If your RAD LINE inspection results are satisfactory and the damage is limited to a small area near the end(s) (fuzzy or soft spots, swelling, cuts, sheath slippage...), you can extend your RAD LINE's life by cutting off the ends.
You will need adhesive tape (strapping tape or duct tape) a SPATHA and a lighter.
1. Cut the cord in the damaged area to free the sheath from the core.
2. Pull on the sheath.
3. Locate the area where the core is present.
4. Use tape to mark the place to be cut, at least 5 cm from the damaged area.
5. Wrap a piece of tape tightly around your RAD LINE, cut and singe the new end of the RAD LINE to prevent fraying.
Attention: if you do this operation multiple times or if you cut off a long piece, your RAD LINE will be shorter than its initial length and the middle mark will no longer be accurate.
Check the accuracy of the middle mark by following the procedure below.
Case 1 - The difference in length between the strands is less than 60 cm: your rope still meets the UIAA standard requirement for a middle mark.
Case 2 - The difference in length between the strands is more than 60 cm: trim the longer side of your RAD LINE before marking the new RAD LINE length on one end.