Crevasse fall: hauling on a rope with knots - Petzl USA
Search

Crevasse fall: hauling on a rope with knots

Tying knots into the rope is valuable in helping to brake a fall into a crevasse when there are only two team members tied in. In case of a fall, and without a second rope available, the victim must be hauled up on a rope tied with knots, which can not pass through a rope clamp at the head of the system. The method for untying the knots requires little additional equipment.

Warnings

  • Carefully read the Instructions for Use used in this technical advice before consulting the advice itself. You must have already read and understood the information in the Instructions for Use to be able to understand this supplementary information.
  • Mastering these techniques requires specific training. Work with a professional to confirm your ability to perform these techniques safely and independently before attempting them unsupervised.
  • We provide examples of techniques related to your activity. There may be others that we do not describe here.

Transferring the load to the rope clamp below

The load must be transferred temporarily onto the rope clamp below, which is connected to the anchor, in order to slacken the rope and untie the knot.

1. Once the hauling system is in place, raising the victim moves the knots toward the system.

Raising the victim moves the knots toward the system

2. Move the TIBLOC-type rope clamp below the knot to the other side of the knot. The TIBLOC is not loaded and can simply be removed.

Move the TIBLOC-type rope clamp below the knot to the other side of the knot

3. With the weight still on the pulley, install a long sling (120 cm) onto the anchor and connect it to the TIBLOC. Push the TIBLOC downward until the sling is at maximum tension.

Install a long sling (120 cm) onto the anchor and connect it to the TIBLOC


4. Carry out a small pull on the system to briefly release the cam of the MICRO TRAXION. Allow the load to descend under tension onto the sling and TIBLOC.

Allow the load to descend under tension onto the sling and TIBLOC

5. With the load on the TIBLOC, only the sling and the lower rope are taut. Untie the knot.

Untie the knot.

6. After untying the knot, check that the MICRO TRAXION's cam is engaged and continue normal hauling on the system. After the first movement, disconnect the sling from the TIBLOC, until the next knot.

Resume normal operation of the haul system.