Crevasse rescue no. 2: accessing the edge of the crevasse to evaluate the situation
Once the fall has been arrested and the victim's weight transferred to the anchor, it is necessary to access the edge of the crevasse to assess the victim's condition before starting the haul.
- Read the technical notice before viewing the following techniques.
- It is important to fully understand the information provided in the technical notice before using this complementary information
- Mastering these techniques requires training.
- Consult a professional before attempting to perform these techniques on your own.
The person on the surface, the "rescuer", must always be anchored. If creating a second anchor is not possible, the rescuer can use the same anchor as the victim. The rescuer's movements must be done with the rope under tension to avoid a shock load in case of a fall, which could weaken the anchor.
Moving with an autoblock knot on the victim's rope
If the "rescuer side" of the rope is too short, it is possible to move with the autoblock on the taut rope supporting the victim. The rescuer must tie-in again as soon as possible after returning to the anchor.
Warning: in this case, if the rescuer falls, for example if the crevasse lip collapses, both climbers will be held by the same rope. The stresses on the system will be significant (anchor + progress capture pulley).
- The anchor could fail, causing both climbers to fall
- If the anchor holds, the rope could be damaged or cut by the MICRO TRAXION's cam, especially if the rope is thin (See test results at the end of this document)
Moving with an autoblock knot on the rescuer's rope
The autoblock allows the length of the rescuer's belay rope to be constantly adjusted, without needing to untie from the rope.