Techniques to improve returning to the trunk with SRT - Petzl Luxembourg
Search

Techniques to improve returning to the trunk with SRT

For better efficiency and convenience while moving along a branch with SRT, various techniques provide the self-hauling effect that is a key benefit of DdRT techniques.

Warnings

  • Carefully read the Instructions for Use used in this technical advice before consulting the advice itself. You must have already read and understood the information in the Instructions for Use to be able to understand this supplementary information.
  • Mastering these techniques requires specific training. Work with a professional to confirm your ability to perform these techniques safely and independently before attempting them unsupervised.
  • We provide examples of techniques related to your activity. There may be others that we do not describe here.

Note: in this document the name ZIGZAG means either the ZIGZAG or ZIGZAG PLUS models.

The principle is to temporarily create a fixed point on the taut rope between the arborist and the tree-top, which will function as a redirect to double the rope.

1. Recommended technique with the free rope

ZIGZAG, recommended technique with the free rope 1/3
ZIGZAG, recommended technique with the free rope 2/3
ZIGZAG, recommended technique with the free rope 3/3

Advantages

  • No change in protection system configuration: the effectiveness of the rope clamp used at the redirect point does not affect user safety
  • The system switches to 2:1 self-hauling
  • Better ergonomics when returning to the trunk because the arborist can pull on all of the rope in front of him/her, with nothing to limit stroke length.
  • The non-retrievable version can be installed at any time with bodyweight on the rope, without the need to be tethered.

Disadvantages

  • You must keep the free rope with you at all times while moving (e.g. by passing it through a CARITOOL on the harness). If the free rope gets away from the arborist, the self-hauling benefit is lost (without posing any specific hazard).

Variations

The redirect point can be fixed with BASIC + ROLLCLIP, it will thus be necessary to go back up to the redirect point to dismantle the setup when the work is done.

A retrievable setup is possible using the RING OPEN + ROLLCLIP or RING L + ROLLCLIP. In this case, the RING is held in place only by friction: the redirect point will stay fixed on the rope as long as it is taut, and will become movable (and thus retrievable) once the rope is slack.

Fixed option:

ZIGZAG, recommended technique with the free rope, variation 1

Retrievable option:

ZIGZAG, recommended technique with the free rope, variation 2
Information

Note on using the BASIC on 11.5 - 13 mm ropes:

The BASIC is designed for ropes up to 11 mm in diameter: it is not compatible with ropes that are usable with the ZIGZAG. Larger-diameter ropes can be difficult to insert into the device.



Locking performance has been verified as satisfactory.

The BASIC does not slide very well on large-diameter ropes; this is why it cannot be used in its main application (rope ascent) on ropes larger than 11 mm in diameter. In the use presented here, no sliding is required, so the BASIC may be used.



For greater efficiency, use the ASCENSION, which is compatible with ropes up to 13 mm.


2. Possible technique with the free rope and a redirect on the ZIGZAG

This technique observed in the field requires special precautions.

ZIGZAG, possible technique 1/3
ZIGZAG, possible technique 2/3
ZIGZAG, possible technique 3/3
Information

WARNING: this technique modifies the main protection system: the rope clamp used for the redirect becomes the primary anchor for the system. Any failure of the rope clamp would cause a dangerous fall (rope clamp safety catch rubbing on a branch, poor positioning of the rope clamp or ROLLCLIP, risk of the BASIC tearing the rope under forces greater than 5 kN depending on the rope...).

Advantages

  • The system switches to 3:1 self-hauling.

Disadvantages

  • The user must be tethered to set it up, because it is necessary to unload the rope between the ZIGZAG and the anchor, and to remove the CHICANE. So it’s not possible to set it up just anywhere.
  • Ergonomics when returning to the trunk are not improved because the arborist must pull the segment of rope between him/herself and the ZIGZAG, which means a limited stroke length (unless an adjustable bridge is used to extend the ZIGZAG when returning to the trunk, as in DdRT).

Note

The retrievable version is not recommended for this technique, due to the risk of the RING OPEN slipping on the rope (undefined locking ability, dependent on rope diameter and condition, the RING’s wear state...). The system has been slow-pull tested to 4 kN without slippage, with new RING OPEN + ROLLCLIP + FLOW. No drop testing has been done on this system.

ZIGZAG: retrievable version, not recommended
Information

WARNING: the CHICANE must not remain in place between the ZIGZAG chain and the rope redirect point. Significant risk of the CHICANE’s handle pressing on the ZIGZAG’s release lever, which could cause a fall.


3. Not recommended technique with the free rope and a redirect on the CHICANE

This technique observed in the field is not recommended with the CHICANE.

ZIGZAG, not recommended technique

The arborist entrusts the safety of the entire system to a single removable pin held by a single screw (the CHICANE’s upper friction pin). This pin is not a tested and certified attachment point. The slightest failure could cause a dangerous fall.



In addition, there is a risk of breakage of the CHICANE’s plastic stopper which was not designed for this use (breakage not accepted in after-sales service).