Wrong attachment of the rope end to the ZIGZAG (DdRT usage)
Basic Techniques
Warning
- Carefully read the Instructions for Use referenced in this Tech Tip before reading the Tech Tip itself. You must have read and understood the Instructions for Use to understand this supplementary information.
- Performing these techniques requires specific training. Work with a professional to confirm your ability to perform these techniques safely and independently before attempting them unsupervised.
- We provide examples of techniques related to your activity. Other techniques not described here may also exist.
Note: in this document the name ZIGZAG means either the ZIGZAG or ZIGZAG PLUS models.
Reminder: the attachment recommended in the Instructions for Use, for a ZIGZAG used in double mode
Other attachment methods that are possible but not recommended
Rope end attached to the harness
Rope end attached to the auxiliary attachment point, which is not equipped with a means of positioning the connector.
Performance
Blocking and descent control performance are the same in the two configurations.
Connector positioning
The connector will not be positioned as well as it would by the integrated positioning ring in the ZIGZAG’s rope end attachment hole. During use: verify that the connector is correctly positioned and interacting properly with your equipment.
Premature wear
The device is out of balance if the rope end is not connected to the intended location. The frame of the device tilts, as the friction chain and the attachment point to the harness tend to line up.
The rope rubs especially on the plastic part between the two side plates, accelerating wear on the device.
